Skip to content

Area and line tools ​

Select one shape or several (see Select several shapes): the selection bar offers the tools that fit. Shapes with heights are never changed by these tools.

Each tool shows what it will do before it does it, and changes nothing until its own button is pressed; the change is then one Undo step. Esc, Cancel, choosing another layer or saving leaves the shapes as they were.

Areas ​

  • Merge (two or more areas of an editable layer): one shape from all of them, previewed in green. Choose whose fields it keeps (the largest area by default); the others are deleted. Areas that do not touch become one shape in several parts.
  • Clip: the selected area is the cutter, and it cuts every shown, editable area under it, in any layer. The cutter itself never changes, and can be in a linked Mapplex or Google Sheet layer. To cut a building out of its plot, select the building. The side panel lists the areas it cuts, each with a tick to leave it alone.
    • Cut away removes what lies under the cutter: the plot gets a hole where the building stands.
    • Keep inside keeps only what lies under the cutter.
    • Split keeps both: the part under the cutter becomes a shape of its own with the same fields.
  • Split (single-part areas): draw a line across the area, from outside to outside. Double-click or Enter splits it at once, and Split goes on with the pieces until Esc or Done. The largest piece keeps the shape's identity; every piece keeps its fields. Tick Preview before applying to see the result first.

Cut out after drawing. When an area you have just drawn lies over other areas (a building on its plot), the message offers Cut it out: one click cuts it out of all of them, and the area tool stays on for the next building.

Lines ​

  • Trim: the line is cut where it crosses other lines and area outlines. Click the pieces to remove; they turn red, with their lengths. Mark the ends past the crossings marks the overshoots at once.
  • Extend: each end is lengthened straight on to the first line or area outline it meets in view. Untick an end to leave it as it is.
  • Split: click where to cut the line. Near a crossing it cuts exactly there; Cut at every crossing cuts at all of them. Each piece keeps the line's fields, the longest keeping its identity.
  • Join (two or more lines): the lines become one, end to end. Choose whose fields it keeps (the longest line by default). Lines whose ends do not meet become one line in several parts.

Before a click, the map shows what it would do: the piece under the pointer lights up red to go (teal to stay), the extension to take, or the place a cut would go. Inside a tool, Ctrl Z undoes the last click.

Spatial intelligence. Clear next steps.